Send Radio Frames 2 (Eqs Mode) - Michael MBWBLUE Mode D'emploi

TL:
[255 bytes]:
To deactivate the radio frame sending, send this command with the correct index IX and [TL] = 0.

Send Radio Frames 2 (EQS mode)

This command is in principal the same as before with the exception that the radio mode (RM) is set to
0x80. In this case a proprietary EQS mode is used.
NOTE: This command is only available with firmware version 3.34 and up.
NOTE: If the "Send Radio Frames" command has been used and is still active ([TL] not 0), then
the radio frames configured with Send Radio Frame 2 are inactive. Send the command "Send
Radio Frames" again with [TL] = 0 to deactivate the "Send Radio Frames" configured radio
frame.
NOTE: The length byte contains only the LSB of the real length (0x116) of this command.
Request:
Answer OK:
Answer Error:
IX:
NU:
CT:
RM:
DL:
S0, S1, S2:
22
Number of bytes to send (length of radio frame)
The radio frame to send. It must contain all CRC bytes but neither
preamble nor synchronization word. The radio frame is automatically
transferred to Manchester code for mode S2 and T2.
It is necessary to always send 255 bytes using this command. The length is
given by TL (see above). Not used bytes should be set to FF.
01 FE 16 4B IX NU CT RM DL S0 S1 S2 A0 A1 A2 A3 A4 A5 A6 A7 TL NF CL
CM [252 bytes] CRC CRC
01 FE 07 4B 00 CRC CRC
01 FE 07 4B FF CRC CRC
Index of configured radio frame to send [1..5]. Invalid IX are ignored.
ignored, set to 0
delay adjust (DL) in 0.5 ms, set to 0 by default.
01 = DL + 0.5 ms
02 = DL + 1 ms
FF = DL – 0.5 ms
FE = DL – 1 ms
etc.
Radio mode:
always set to FF
always set to S2 = 01, S1 = 86, S0 = A0
MBWBLUE
80 = EQS mode