Publicité
Les langues disponibles
Les langues disponibles
Reversing switch action
1
A
B
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
tion (A side) for clockwise rotation or the
side) for counterclockwise rotation.
CAUTION:
•
Always check the direction of rotation before opera-
tion.
•
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
Hook
The hook is convenient for temporarily hanging the tool.
When using the hook, pull it out in A direction and then
push it in B direction to secure in place.
When not using the hook, return it back to its initial posi-
tion by following the above procedures in reverse.
A
002635
1. Reversing
switch lever
002644
1. Hook
1
002645
B
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
To remove the bit, first pull the locator out of the locking
sleeve. Then grasp the bit with a pair of pliers and pull the
bit out of the magnetic bit holder. Sometimes, it helps to
wiggle the bit with the pliers as you pull.
posi-
position (B
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the locking sleeve.
OPERATION
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
•
When fitting the screw onto the point of the bit, be
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
5
002653
1
2
002661
1
2
3
002673
1. Locator
2. Locking sleeve
1. Locator
2. Bit
3. Magnetic bit
holder
Publicité
