Scansonic P3600 Guide D'instructions page 15

OPERATING THE UNIT IN AUX-IN MODE
Aux In mode plays audio from an external source such as an MP3 player.
1. Plug one end of the 3.5 mm audio cable (included) into the headphone
or line out jack on your player, plug the other end of cable into the unit
AUX-IN jack on the back of the unit.
2. Turn on the external audio source and play your device.
3. Press and hold the STBY/FUNC button to turn on the unit during
standby mode.
4. Short press the STBY/FUNC button until
the "Auxiliary Input Mode" appears on the
display to select AUX-IN mode.
5. The volume level can now be controlled
through the main unit. Operate all other
functions on the external device as usual.
Notes:
1) If you're connected to the Line out Jack of your external device,
then you only need to adjust the volume control of this unit. If you're
connected to the Headphone Jack of your external device, then you
may need to adjust both the volume control of your external device and
the volume control of this unit to find the most desirable volume setting.
2) Slide the Power ON/OFF switch to OFF position to turn off the unit when
you finish listening.
Don't forget to switch off the power of your external device as well.
Sleep Timer Setup
- During operating mode, press and hold the
MENU button to enter sleep timer setting
mode, press "DOWN" or "UP" to adjust the
sleep delay time in minutes from: Sleep off
/1/20/30/60/90/120, the sleep icon "ZZZ"
flashes on the display.
- Press the OK button to confirm the setting, the sleep icon "ZZZ" will stop
flashing.
- Select "Sleep off" to cancel the sleep mode, the sleep icon "ZZZ"
disappears simultaneously.
- When the sleep timer is active, press and hold the MENU button to
show the current sleep time, press "DOWN" or "UP" to modify the
setting.
P3600
FM DAB+
15