Scansonic P3600 Guide D'instructions page 10

OPERATING THE UNIT IN DAB MODE
DAB radio mode receives DAB/DAB+ digital radio and displays information
about the station.
Auto Scan
1. Fully extend the telescopic antenna.
2. Press and hold the STBY/FUNC button to
turn on the unit during standby mode.
3. Short press the STBY/FUNC button to select
DAB mode.
For the first time use or if the station list is
empty, the radio automatically performs a full
scan to see what stations are available, the
display shows the scan progress and the total
channel number during the scanning.
4. When the scan progress is completed, it will then set the time and start
playing the first station on the station list it finds.
5. To change the station, press "DOWN" or "UP" button to scroll through
the list of stations and press OK button to tune to the displayed station.
The Now playing screen is displayed with the new station details.
6. If no stations are detected during the scan the display will show "NO
DAB Station".
Notes:
1. Just like Digital TV there are some areas where it may still be difficult to
get a good DAB signal. The broadcasters are constantly improving DAB
coverage, so in some cases it may be necessary to wait before some
or all DAB services become available. You can check coverage for your
area.
2. You may also need to start a scan manually to update the list of stations
for one of the following reasons:
- New stations may become available from time to time.
- Stations close or can no longer be received (In the station list, invalid
stations are indicated with a question mark "?" in front of their name).
- If reception was not good for the original scan (for example the antenna
was not up), this may result in an empty or incomplete list of avail able
stations.
10
P3600
FM DAB+