Tips For Use - Garland BOLT 115-V1 Manuel D'instructions

English
7.1. USING THE MACHINE
- Start the machine following the instruction in the
manual.
- For 3 minutes keep circuit breakers in the OFF
position to warm up the engine without load.
- If you are using alternating current (AC) select
the circuit breaker in alternating current (AC).
- Connect the appliance to the generator.
- If the connected device has higher consumption
that the generator can produce, the circuit breaker
will cut off electricity supply to protect the
generator.
- If this occurs unplug the electricity for at least one
minute, reconnect the circuit breaker.
7.2. VERIFICATION POINTS AFTER COMMISSIONING
Check that the noise of the machine is normal and
that it does not vibrate. If you detect any anomaly
in the machine stop immediately. In case of any
malfunction or problem take the machine in for
service to be repaired. In no circumstance should you
continue to use the machine if the operation does not
seem appropriate.
Check the voltmeter brand 220-230V. If the voltmeter
mark voltage is too high or too low to stop the
machine immediately.
Do not use the machine if it is damaged or improperly
adjusted.

7.3. TIPS FOR USE

- If you are connecting two or more devices to the
generator, connect them one by one starting with
the one using the most power.
- Remember that most of the devices require
more power than specified in the label to boot. It
could happen that this generator, although capable
of supporting the consumption of the appliance in
operation, cannot generate the energy needed for
its start-up.
- If you use this generator to give power to a
circuit of a house have the operation performed
by a qualified electrician. Inadequate connections
between the generator and the home appliances
could lead to severe damage to the generator and
to the connected devices or lead to fire.
34/84