Dispensing Of Beverages - Coffee; Special Functions - LaCimbali S39 TE Utilisation Et Installation

GENERAL INFORMATION
Place the cup (or cups) under dispenser (1) of the required
group.
Adjust the height of the dispenser (1) if necessary.
Press the coffee dispensing key relative to the selected
dose. The led of the selected key lights up and dispensing
commences.
Dispensing stops automatically.
Delivery of powdered coffee for machines without
automatic dosers
After having positioned the cup under the spout,open the
decaffeinated coffee panel (18) and measure out a dose
of powdered coffee into the tube and close the powdered
coffee panel (18). The leds relative to the keys programmed
for one cup located on the display panel (3) will blink.
Also, keys in second selection and special key will blink
alternatively if programmed (see paragraph "Special
function" on the following pages).
Press one of the keys associated to the ignited leds that
corresponds to the desired dose.
Delivery terminates automatically.
Coffee STOP function
Use "OK" key to stop coffee dispensing before the
programmed dose has been reached.
NOTE: use of the "OK" button will not modify the
programmed parameters.
SECOND SELECTION Function
The special function key (Shift) described here below can
only be activated by an installation technician.
Enables the dispensing of a second type of drink associated
to the dispensing keys.
Menu 1 (red led ignited): indicates that the
machine dispensing keys are associated to
Menu 2 (green led ignited): indicates that the
machine dispensing keys are associated to the
beverages in the second selection.
This function can be obtained only after
programming the special key (Shift), with the second
selection function in the
At this point, when the special key is pressed, the green
led ignites. If one of the dispensing keys is pressed for the
desired beverage and dose, the second beverage set for
the selected key will be dispensed.
N.B.: To cancel the second selection operation press
the key again (Shift).

12. Dispensing of beverages - Coffee

12.1 Special functions (where contemplated)
of the machine.
18
SECTION REPETITION Function
This function can be activated in various ways:
1) Press any one of the selection keys and after about 3
seconds press the same key again for the number of
dispensed drinks required.
The number of dispensed drinks programmed is
indicated on the top left of the display. Press the "OK"
key and keep pressed for about 3 sec. to reset.
2) Setting the desired number at the repeats entry in the
beverage recipe (see CLIENT PROGRAMMING and
paragraphs referring to Key Menu).
NOTE: These functions are deactivated when error
messages and/or codes are displayed and the
item "Program. block" is set on "YES".
When the Shift key is activated, there will be 7 normal
selections and 7 second selections available, for a total of
14 possible recipes.
When it is activated, the Shift key is always on the right
13 EN
OK
3
1
Shift