Baumer VeriSens ID Guide D'installation Rapide page 10

Instructions on commissioning of the Ethernet interface
To use VeriSens
The default factory configuration is:
1. If your network has a DHCP server, the IP address will request from that server.
You do not need any further manual adjustments.
2. If a valid IP address can not be determined within 15 seconds, the following
network configuration is used:
Default IP address: 192.168.0.250 (Subnet mask: 255.255.255.0)
My device is not located in the selection list after launching the
Application Suite ?
1. Check that the power cable of VeriSens
2. Make sure that your PC and VeriSens
3. Check the network settings of your PC, especially the IP address and
EN
subnet mask. Contact your administrator possibly.
4. Make sure that each IP address is unique in your network!
Industrial Ethernet
The models VS xxxxxxxxxxxIP integrate Industrial Ethernet
(PROFINET / EtherNet/IP
Activation:
Detailed instructions can be found in technical documentation.
10 10 EN
® in your network, you must assign the device a unique IP address.
™ ).
Device ➞ Device settings... ➞ Process interface
® is connected correctly.
® are connected in the same network.