Baumer VeriSens ID Guide D'installation Rapide page 5

ATTENTION!
Incorrect voltage will destroy the device: Pin 1: Power (+18...30 VDC)
!
Electrical connection
M12 / 12-pin, A-coded
1: PWR (+18...30 VDC) Brown
2: Ground Blue
White
3: IN1 (Trigger)
4: OUT1 Green
5: IN2 Pink
6: OUT2 Yellow
The duration of the output signals and the time of output are adjusted by software and
depend on the current job.
Ethernet connection
NOTE
To avoid network
malfunctions, ensure that
each IP address is unique
within your network!
1)
7: OUT3 Black
8: IN3 Gray
9: OUT4 / RS485+ Red
10: IN4 Violet
11: IN5 Gray-Pink
12: OUT5 / RS485- Red-Blue
Start the Application Suite . The VeriSens
must be connected to the same network. By default, the
use of DHCP is enabled. If a DHCP server is not found
within 15 seconds, the following network configuration
is used:
IP address:
Subnet mask:
For more information, please see page 10.
English
Pin 2: Ground
Ethernet Electr. connection illumination
1)
M12 / 4-pin
1: TD+ 1: +24 V or +48 V Flash
2: RD+ 2: +12 V or +24 V Flash
3: TD- 3: Ground
4: RD- 4: Flash Sync
on device
1)
voltage outputs configurable by software
2)
192.168.0.250
255.255.255.0
1)
M8 / 4-pin (XC only)
2)
® and your PC
EN
EN
5 5