AEG HG654421 Notice D'utilisation page 13

A
A) Rigid copper pipe or flexible pipe of
stainless steel
8.5 Replacement of the
connection cable
To replace the connection cable use on-
ly H05V2V2-F T90 or equivalent type.
Make sure that the cable section is appli-
cable to the voltage and the working
temperature. The yellow/green earth
wire must be approximately 2 cm longer
than the brown (or black) phase wire.
8.6 Building In
min.
200 mm
min.
55 mm
30 mm
480 mm
A)
B)
8.7 Possibilities for insertion
Kitchen unit with door
min.
650 mm
The panel installed below the hob must
be easy to remove and let an easy ac-
cess in case a technical assistance inter-
560 mm
vention is necessary.
A)
B)
Kitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven from the unit.
B
supplied seal
supplied brackets
CAUTION!
Install the appliance only on a
worktop with flat surface.
If you install the hob under a
hood, please see the installation
instructions of the hood for the
minimum distance between the
appliances.
A
60 mm
B
Removable panel
Space for connections
ENGLISH
13
A
30 mm
min 20 mm
(max 150 mm)