Decalcification; Storage; Troubleshooting - Profi Cook PC-ES 1109 Mode D'emploi

NOTE:
Fill a bowl with hot water to remove dry residue.
Set it so under the steam tube that it is immersed
in the rinsing bath.
3. After the cleaning, screw the steam nozzle again
onto the steam tube. Place a heat-resistant empty
bowl under the steam nozzle. Operate the appli-
ance as instructed under "Making Cappuccino"
points 4 and 5. After cleaning the steam nozzle is
again ready to use.

Decalcification

Scale deposits put the functionality of your appliance
at risk. It is necessary to decalcify the appliance
regularly. The intervals depend on use frequency and
water hardness.
Decalcify with a commercial decalcifier for coffee
machines.
Problem Possible cause
The appliance does The appliance has no power supply.
not function.
The appliance has not been bled before
first-time use.
The appliance is faulty.
No coffee output.
The water tank is empty.
The water tank is not properly attached;
the valve is not open.
The holes in the filter holder and the
group head outlet are blocked.
Air entrapped in the heating circuit.
The coffee grounds are too fine or
compressed too much.
Scale deposits in the appliance.
The pump is noisy.
The water tank is empty.
The water tank is not properly attached;
the valve is not open.
Air entrapped in the water circuit.
PC-ES1109_IM
1. Dose as instructed on the packaging or on the
instruction leaflet.
2. Operate the appliance as instructed for making
espresso until the tank is empty. Let the solution
flow through the group head (without filter holder).
WARNING:
• Rinse the water tank and let one full tank fresh
water flow through the group head to rinse out the
decalcifier residues.
• Do not use this water for making espresso.
• Clean the appliance as instructed. Let the accesso-
ries dry completely.
• We recommend that you keep the appliance in the
original packaging if the appliance will be not used
for long periods.
• Always keep the appliance out of the reach of chil-
dren in a dry, well ventilated place.

Troubleshooting

Solution
Test the socket with another appliance.
Plug in the mains plug correctly.
Check the main circuit breaker.
Bleed the appliance as instructed under "First
Use / Bleeding".
Contact our service center or a specialist.
Switch the appliance off!
Fill the water tank with fresh water.
Press the tank slightly down for the valve to
open.
Clean filter holder, filter and group head outlet.
Generate steam as instructed under "Making
Cappuccino". Set the rotary switch to the
position.
Loosen the coffee grounds. Spread it evenly
and only slightly compress with the tamper.
Decalcify the appliance as instructed.
Switch the appliance off.
Fill the water tank with fresh water.
Press the tank slightly down for the valve to
open.
Bleed the appliance as instructed under "First
Use / Bleeding".

Storage

21.04.16
63