Restore Factory Settings - Allegion SCHLAGE TOUCH Mode D'emploi

Lock Issue
Cannot change
Programming Code.
Cannot delete all User
Codes.
Lock will not stay in
programming mode.
* Number of beeps if beeper is turned on.

Restore Factory Settings

If you lose or forget your Programming
Code, you can restore the factory
settings, which will restore the default
Programming code.
1. Disconnect the battery.
2. Press and release the Schlage button.
3. The following steps must occur within
10 seconds:
a. Reconnect the battery. The
indicator light will light green for
one second.
b. Then, press and hold the Schlage
button until the indicator light is
green and the lock beeps.
4. Try entering one of the default User Codes. If it does not unlock the lock, start over at
step 2.
Once you've done this, you can change the programming code to a personalized number.
See Changing the Programming Code* on page 11.
Beeps* Lights Solution
Second Programming Code entered did not
match first Programming Code entered. See
Changing the Programming Code* on page
2 Red
11.
First four digits of new Programming Code
match an existing User Code.
Programming Code entered second time is
2 Red
incorrect.
Any key other than
immediately after programming mode was
entered.
2 Red
An incorrect entry was made during the
programming process.
Locate the default Programming and User
Codes on the front of this guide or the
back of the touchscreen before beginning!
Default Programming and User Codes will
be restored. All existing User Codes and
current Programming Code will be erased.
CUSTOMER SERVICE CANNOT
RETRIEVE LOST DEFAULT CODES! DO
NOT RESTORE FACTORY SETTINGS
UNLESS YOU CAN LOCATE THE
DEFAULT CODES.
was pressed
WARNING
15