Lindy 38205 Manuel Utilisateur page 6

User Manual
Overview
The following steps are for an installation using HDMI equipment, if you are using DVI equipment, please
substitute HDMI cables for DVI to HDMI cables where required.
▪
Connect your HDMI source to the "HDMI IN" port on the transmitter using a High-Speed HDMI cable.
▪
Connect one end of a Cat.5e/6 cable or higher to the "CAT OUT" port on the transmitter, and the
other end to the "CAT IN" port on the receiver.
▪
To utilize the loop out feature, connect a local display or projector to the "HDMI OUT" port on the
transmitter using a High-Speed HDMI cable.
▪
Connect your remote display to the "HDMI OUT" port on the receiver using an HDMI cable.
▪
Connect the included IR emitter cable to the "IR OUT" port on the
transmitter, and the IR receiver cable to the "IR IN" port on the
receiver.
▪
Ensure the emitters eye is in line with the IR receiver on the source
device.
▪
Ensure that the IR receiver is in a clear line of sight of the remote
control.
▪
Using the EDID switch, select which display you want to take the
EDID from for your alternate display. Select TX to pass-through the EDID from the local display (if
connected) or select RX if you would like to pass-through the EDID from your remote display.
▪
Connect the locking DC power supply to the DC12V port on the transmitter. The transmitter and
receiver will immediately turn on, then switch on the display(s) and finally your source device.
▪
The installation is now complete.
Please note: If you are using two displays with different EDID's, please set the EDID switch accordingly
to enable pass-through from the display with the lowest capability, ensuring maximum compatibility.
English