Publicité
Les langues disponibles
Les langues disponibles
User Manual
Overview
Transmitter
1. Service – Connect a Micro-B cable to this port to perform firmware updates to the transmitter.
2. EDID Switch – Locate the switch up to copy the EDID information from the display connected to the
HDMI out port on the transmitter or down to copy the EDID information from the display connected to
the receiver.
3. IR Out – Connect the supplied IR emitter cable and place the other end of the cable in line of sight of
the IR port on the device to be controlled.
4. POWER LED (green) – Illuminates when the transmitter is receiving power.
5. CAT OUT – Connect a Cat.5e/6 or higher cable of up to 50m to this port and the corresponding port
on the receiver.
6. DATA LED (orange) – Illuminates when the transmitter is receiving a signal from the HDMI source
device.
7. HDMI IN – Connect an HDMI source device, such as a PC, media player or Blu-ray player.
8. HDMI OUT – Connect to an HDMI display for local monitoring or to create an additional viewing
zone.
9. DC12V – Connect the supplied 12V multi-country power supply to the transmitter.
Receiver
1. SERVICE Input – Connect a Micro-B cable to this port to perform firmware updates to the receiver.
2. IR IN – Connect the supplied IR Receiver cable and place the other end of the cable in a location
where it is in line of sight of the IR remote control to be used.
3. POWER LED (green) – Illuminates when the receiver is being powered.
4. CAT IN – Connect a Cat.5e/6 or higher cable of up to 50m to this port and the corresponding port on
the transmitter.
5. DATA LED (orange) – Illuminates when a stable HDMI signal is being received from the transmitter.
6. HDMI OUT – Connect an HDMI cable to a HDMI display or projector.
English
Publicité
