Special Safety Instructions For This Machine; Designated Use; Supplied Parts; Unpacking The Appliance - Profi Cook PC-AE 1002 Mode D'emploi

• Children should be supervised at all times in
order to ensure that they do not play with the
device.
Special Safety Instructions for this
Machine
WARNING
• Risk of cuts! The centrifuge sieve and the mix-
ing blades are sharp!
• If the rotating sieve is damaged, the device
shall not be operated.
• Always use the supplied tamper. Do not insert
your ingers or tools into the iller opening.
• Before replacement of accessories or addi-
tional parts which move during operation, the
device must be switched off and cut off from
the mains.
• Do not touch moving parts.
• Before replacing accessory parts, wait until
the knife has stopped.
• Always check that the accessories are seated
solidly and securely before switching the
device on.
• Do not operate the mixer for more than 1 minute!
Afterwards, let it cool for approximately 3 min-
utes before you use it again.
• Do not touch any moving parts of the machine
and always wait for it to stop.
• The machine should only be used under super-
vision!
• Do not manipulate any of the safety switches!
• Do not remove the lid during operation.
• Do not put your ingers into the iller opening.

Designated use

This device is used for
• Juice extraction from fruit and vegetables
• Mixing of liquids.
Do not use for too hard foodstuffs such as nuts or
chocolate.
It is intended for the use in private households and
similar applications.
It is only to be used as instructed in this user
manual. The appliance is not intended for com-
mercial use.
Any other use shall be considered as not intended
use and can lead to material damage or even
personal injury.
The manufacturer shall not be liable for damages
caused by not intended use.

Supplied parts

1 base device with motor
1 transparent cover
1 tamper
1 centrifuge sieve
1 centrifuge housing
1 pomace container
1 cap for the iller opening
1 lid with iller opening for mixing vessel
1 mixing vessel

Unpacking the appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils,
illing materials, cable holders, and carton
packaging.
3. Check the scope of deliveries for complete-
ness.
NOTE:
There may still be dust or production remains on
the device. We recommend that you clean the
device as described under "Cleaning".

Description of the Parts

1 Tamper
2 Filler opening
3 Transparent cover
4 Safety switch
5 Centrifugal sieve
6 Centrifuge casing
7 Drive wheel
8 Safety bracket
9 Control panel
43