Brandt Transferpette electronic Mode D'emploi page 59

d.
1 x
e.
1 x
f.
1 x
g.
1 x
h.
1 x
i.
1 x
Transferpette® electronic 997209
d.
Preparing for pipetting: Press the pipetting key once to
move the piston to its start position.
ð
The arrow in the display points upwards (aspiration).
e.
Aspirate liquid: Press the pipetting key once to aspirate
the liquid.
When aspirating the liquid, slightly more volume is aspirated
than set.
f.
Dispense liquid in revPIP mode: Press the pipetting key
once to dispense. On the display, the arrow points
down (dispensing). The set volume is now dispensed
and some liquid remains in the tip.
g.
Re-aspirate liquid in revPIP mode: Pressing the pipet-
ting key again now resumes the set volume. (Pressing
the pipetting key again releases the volume)
h.
Trigger blow-out: After the last pipetting, press 'Enter'
key.
ð
The display now once again shows 'blo' for blow-out.
i.
End pipetting: By pressing the pipetting key once, the
blow-out is triggered, and the residual liquid is dis-
pensed.
ð
After dispensing the residual liquid (blow-out), the dis-
play jumps back to the set mode (start position).
5 Pipetting programs
NOTICE
Operating manual
59