LENCO DAR-060 Mode D'emploi page 8

To replace a new battery, please refer to the figure shown below. When inserting a battery, be sure to do so in the proper
direction.
EN
Battery case
Pull out the battery case
Push in according to this direction
CR2025 battery

If the remote control conflicts with other devices, the operation will be affected.

Do not simultaneously press buttons on the unit and the remote control.

Avoid using two remote controls at the same time as it will cause a malfunction.

Use only CR-2025 size batteries.

If there is battery leakage, clean the remote control thoroughly before replacing batteries.

Do not short two terminals of the batteries. Dispose old batteries in a suitable place.
BASIC OPERATION
Plug the AC power cable into the AC wall socket. The display will show "Scan Time". The unit is now updating the time
from the broadcaster. Wait for a while until it is finished and the real time will be display.
Press the STANDBY
DAB/FM/CD/AUX/Bluetooth
Press the SOURCE button to select from different sources.
Volume Control
Turn the VOLUME control or press the VOL-/VOL+ buttons on the remote control to change the volume.
Adjusting the Antenna
The antenna at the rear panel of the unit should be extended to ensure a good DAB/FM reception. Alter the antenna
position for the best reception.
DAB OPERATION
The first time the DAB mode is selected, it will automatically scan for available DAB stations. Wait until the scanning has
finished. The display will show the scanning progress. After scanning it will tune to the first station.
Auto Scan
1. Turn on the unit in DAB mode.
2. Press the SCAN button to start auto-scanning the available stations.
button to turn on the unit. To turn off, press the STANDBY
EN
Battery case
Pull out the battery case
Push in according to this direction
CR2025 battery
8
button again.