Witter DA7U Instructions De Montage

MATERIALS
A 1 Cross Bar
B 2 Side Arm
C 4 M10 x 80 x 1.50 mm Bolts, Washers (40mm OD), Bushes (55mm Long), Washers, Lock Washers and Nuts (10.9)
D 6 M12 x 35 x 1.75 mm Bolts, Washers, Lock Washers & Nuts (8.8 Grade)
ZE 1 Electrical Plate
ZN 1 Neck
FITTING
1. Remove the plastic undertray (pressed nuts, torx screws & clips) from the vehicle and hand back to the customer.
2. Remove tape or plastic grommets from the inner & outer face of each chassis to reveal mounting points. (Note: it is
essential that the holes and mating surfaces are fully clear of any mastic compound and extrusions).
3. Insert the bolts & 40mm OD washers from (C) into inner face of the chassis then slide bushes onto the bolt from the outer
face (take care not to drop the bushes into the enclosed chassis rail). Fit side arms (B) onto the outer face of the
chassis and using the washers, lock washers and nuts from remaining fasteners (C) loosely attach.
4. Fit cross bar (A) between the side arms and attach loosely using fasteners (D).
5. Attach neck option (ZN) in position and attach electrical plate (ZE) to centre profile holes.
6. Fully tighten all fixings to their correct torque settings.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M12 - 95 Nm, M16 - 214 Nm (Grade 8.8) / M10 – 70Nm (Grade 10.9)
Fitting
Instruction
s
µW0001DA7U-FIT$011312140000JÄ
W0001DA7U-FIT$011312140000
Towbar For
DA7U
Dacia Logan MCV
For use with
2013 -
3004 series
necks
DETACHABLE NECK MUST BE
USED IF REVERSING SENSOR
IS LOCATED AT THE CENTRE
OF THE BUMPER