Pattfield Ergo Tools PE-900HO Traduction De La Notice Originale page 89

PARALLEL GUIDE
1 Attach the parallel guide
and set the desired parallel distance.
If the tool is not in use the parallel guide
can be used as a blade guard.
REBATING
1 Attach the rebating depth
shown and set the desired rebating dis-
tance from 0 - 15.5 mm.
DEPTH ADJUSTMENT
1 To set the desired planing depth from
0 - 3 mm, rotate the depth adjustment
knob 2.
Each click adds / decreases 0.5 mm.
BLADE REPLACEMENT
1 Remove the tools from the tool stor-
age 7. Use the wrench and loosen the
three screws.
Caution! Make sure the tool is
switched off and unplugged.
3 Replace the blade or the complete
blade assembly and slide it back into
the tool so that it runs freely.
Caution! Make sure the blade is
placed in the correct position!
BEVELING
4 as shown 2 The three V-grooves in the front of the
base plate allow quick beverling. Place
the V-groove of the desired size on the
edge and guide it along.
guide 10 as 2 Set the disired distance on the parallel
guide 4
as often as necessary to achieve the
desired rabbet.
2 The current depth adjustment can be
read at the arrow.
2 Open the blade cover
the blade assembly.
Caution! The blade is sharp.
4 Adjust the height of the blade assembly
with the hex key and securely tighten
the three screws loosened in step 1.
There are two blades on the spindle!
Caution! Always use identical
blades and blade assemblies!
in order to make rabbets. Plane
9 and slide out
EN 87