Installation Instructions - GEIGER GJ56 Série Notice Originale

f The rated speed and the rated torque of the motor must be compatible with the
device.
f The mounting accessories that are used must be designed in accordance with the
selected rated torque.
f Good technical knowledge and good mechanical skills are necessary for the motor
installation. Incorrect installation can lead to serious injury.
Electrical work must be carried out by a qualified electrician in accordance with the
regulations in force locally.
f Only use connecting cables that are suitable with the environmental conditions and
which meet the construction requirements. (see accessories catalogue)
f If the device is not equipped with a connecting cable and a plug, or other means for
disconnecting from the mains with a contact opening on each pole according to the
conditions of the overvoltage category III for full disconnection, a disconnecting
device of this type must be incorporated into the permanently installed electrical
installation according to the wiring rules.
f Do not mount the connecting cables near hot surfaces.
f A plug for the disconnection of the motor from the power supply must be accessible
after installation.
f Damaged connecting cables must be replaced by GEIGER connecting cables of the
same type.
f The device must be mounted as described in the installation instructions. Fixations
shall not be made with adhesives since they are regarded as unreliable.

6. Installation instructions

I
Prior to installation please check to ensure there is no visible damage
to the motor like cracks or open cables.
I
Before fixing please check the strength of the masonry and of the
surface.
EN
4
EN
Gerhard Geiger GmbH & Co. KG | 100W1583
max.
1,5 Nm
en V001 0516