Media Player - Ibiza sound CUBE212A-ARRAY Manuel D'utilisation

•
Do not place any naked flames such as those of burning candles on or next to the appliance.
•
Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the appli-
ance. Do not obstruct the air circulation with objects such as magazines, table cloths or curtains. This pre-
vents the dissipation of heat from the appliance and can result in overheating.
•
Only use the appliance in a moderate climate, not in tropical environments.
•
Defective mains cables may only be replaced by specialists. Danger of shock hazard!
•
If you are not sure about the correct connection or if questions arise which are not answered by the operating
instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if you
are in doubt the operating principle or the safety of the product.
MEDIAPLAYER
1. MODE: Press this button to switch among all input
modes
2. PREV: Press this button to go back to previous track
3. Play/Pause: Press this button to pause the playing.
Press again to play
4. NEXT: Press this button to go to next track
5. REPEAT: Press this button to repeat all tracks, repeat
current track or play random tracks
6. Mute: Press this button to mute the unit
7. SD: Connect your SD card here
8. USB: Connect your USB card here
9. MIC VOL: Use this knob to adjust the volume of micro-
phone
10. MIC ECHO: Use this knob to adjust the echo of micro-
phone
11. TREBLE: Use this knob to adjust the treble of output
12. BASS: Use this knob to adjust the bass of output
13. SUB VOL: Use this knob to adjust the volume of sub
output
14. Master VOL: Use this knob to adjust the master
volume
REAR PANEL CONNECTIONS ACTIVE BOX
1. MIC INPUT: Connect your microphone here
2. LINE INPUT: Connect your line signal here
3. AUX INPUT: Connect your AUX signal here
4. AUX OUTPUT: Connect this line output signal to the
input of another amplifier or active speaker.
5. MIX OUTPUT: Connect this output to the input of
another amplifier or active speaker.
6. SAT OUTPUT: Connect the 2-pin SPEAKON cable to
this output and the other end to a satellite speaker
7. SUBWOOFER OUTPUT: Connect the 4-pin SPEAKON cable to the SUBWOOFER IN connector (B) on the
passive subwoofer.
REAR PANEL CONNECTIONS PASSIVE BOX
A. 2-pin SPEAKON output: Connect the 2-pin SPEAKON cable to the satellite
speaker
B. 4-pin SPEAKON input: Connect the 4-pin SPEAKON cable from the active
subwoofer (7) to this input.
CUBE212A-ARRAY
www.ibiza-light.com
MEDIAPLAYER
CUBE212A-ARRAY
MODE 1 2 3 4
7
VOLUME
SD
MIC VOL MIC.ECHO TREBLE
9 10 11
0 10 0 10 -10 +10
1 2
INPUTS
MIC LINE
5 RPT MUTE/ 6
8
USB
BASS SUB.VOL VOLUME
12 13 14
MIN MAX
-10 +10 0 10
5
AUX OUTPUT
3 4
L L
3 4
R R
IN OUT MIX OUTPUT
6
SAT 1
7
SPEAKER
OUTPUT
POWER
ON
OFF
Consumption/consommation: 400W
BT Freq.:2402 - 2480MHz
Max. RF power/puiss.Max RF: 2.84dBm
220-240v ~50/60Hz
Fuse: T3.15A
REF.Nr.:
Serial Nr.:
CUBE212A-ARRAY
A B
USE WITH CUBE212A-ARRAY
SUBWOOFER ONLY
PIN 1 - SAT 2
PIN 2 - SUB 2
EN
3 3