Prohibitions:
General prohibition
(in connection with any other
icon)
Warning:
Warning/Caution
Commands:
Please read carefully the
Operating Instructions.
Environment protection:
Dispose waste professionally
so as not harm the
environment.
Any defective and/or disposed
electric or electronic devices
must be delivered to
respective collection centres.
Package:
Protect against moisture!
Caution – Fragile!
This side up!
Technical specifications:
Voltage ~ frequency
Suction hose Ø
Tank capacity
Other:
Please clean after each use!
Warning against dangerous
voltage
Packing cardboard material
may be delivered to
collecting centres for
recycling.
Interseroh-Recycling
system with serial number
Engine output
Suction hose length
Weight
Hot coal not to be
vacuumed in any case!
Noise
Assembly / first start-up
1.
Take the appliance out of the package and fit the suction
nozzle (pos. 1/1) on the suction hose (pos. 1/5) first
2.
Insert the other end of the suction hose to the air intake
(pos. 1/3)
The Güde GA 18L ash vacuum cleaner is now ready for
operation.
Operating
Safety instructions for first start-up
Use exclusively approved extension cables for outdoor
works.
The plug and socket must be waterproof and the cable
must be of the necessary length and have the following
cross-section:
2
1.5 mm
with maximum length of 10 m or 2.5 mm
maximum length of 15 m. Unsuitable extension cables can
be dangerous!
Do not vacuum toxic, caustic and deleterious substances
with this appliance.
Do not vacuum water or any other liquids with this
appliance.
Do not vacuum bigger pieces of charcoal with this
appliance as they could get jammed within the hose.
Do not vacuum hot or burning or smouldering substances
(e.g. hot ash) with this appliance.
Use the appliance exclusively for vacuuming of cold ash.
Do not vacuum heating boilers and oil stoves and plaster
and cement dust with this appliance.
Switching the engine on
Put the switch (pos. 1/6) to the "ON" position
Switching the engine off
Put the switch (pos. 1/6) to the "OFF" position
Filter change
If you want to change or clean the filter insert, remove it by
screwing it out (pos. 2)
Inspections and maintenance
Safety instructions for inspections and maintenance
The appliance, especially the suction nozzle needs to be
cleaned after any use!
Regular maintenance is necessary for proper working of
your appliance.
Regular cleaning and maintenance of the suction nozzle must
especially be carried out to prevent damage and accidents in
general.
The following needs to be provided before maintenance:
- disconnect the plug,
- put the appliance to a stable position,
- wait until the engine cools down.
Have any repairs unconditionally executed by trained
professional staff.
Disconnect the plug before every alteration, adjustment or
maintenance of the appliance!
2
with