Control Panel; Switching On And Off; Setpoint Setting - Studio 54 GN PREMIUM Mode D'emploi Et D'entretien

This product must not be disposed of together with other commercial waste. For the incorrect disposal of
WEEE-marked products, financial penalties are applicable to the non-complying user.

12. Control panel

LED KEYS
1 UP
2 DOWN
3 Compressor LED
4 Fan LED
5 Defrost LED
6 Alarm LED
7 STAND-BY (ESC)
8 SET

13. Switching on and off

To turn on the refrigerator, simply turn the green switch to the ON position with the light on. The display will
flash for 3 seconds after which the internal temperature of the cell will be signalled and the refrigeration
cycle will begin.
During the operating cycle, the LED will light up at the snowflake (no. 3) and the LED of the internal fan will
light up. (n°4)
To turn off the refrigerator, simply turn the green switch to the OFF position with the light off

13.1 Setpoint Setting

Determine the Set point: to display the value of the Set point press key 8: the word "Set" will appear.
Pressing key 8 again will bring up the current value of the Set point on the display.
To change the value of the Set point, use keys 1 and 2 within 15 sec. To confirm the change press key 8.
Set point means a temperature value that the product must reach
With a tolerance of 2°C higher.
Press and release - Scrolls through the menu items Increases the
values
Press for at least 5 sec - Activates the Manual Defrost function
Press and release - Scrolls through the menu items Decreases the
values
Fixed on: compressor active
Flashing: delay, protection or activation blocked
Fixed on: fans active
Fixed on: defrost active
Flashing: manual activation
Fixed on: presence of an alarm
Flashing: alarm
Press and release - Returns to one level above the current menu
Confirms parameter value
Press for at least 5 sec - Activates the Standby function
(when not in menus)
Press and release - Displays any alarms (if present) Accesses the
Basic Commands menu
21