Hendi 210000 Mode D'emploi page 5

Instructions for use
• Position the appliance so that the on/off switch is
facing the user.
• If the blade sharpener has not been installed, pro-
ceed as follows:
- Position the blade sharpener in its support so
that the blade does not extend between the
gears.
- Tighten the safety screw on the blade sharpener.
• Turn the appliance off (the appliance is equipped
with a safety switch and will turn off automatically
if the sharpening device is removed)
• Push the plug in the wall socket.
Cleaning and maintenance
• Turn the slice thickness dial in counter clockwise
direction to the "0" position,
• Always pull the plug from the socket before clean-
ing the appliance.
• Warning: Never submerge the appliance in water
or other liquids!
• Use a damp cloth to clean surfaces (solution of
water and a mild cleaning agent).
• Never use corrosive or abrasive cleaning agents.
• Turn the dial with the graduated scale to the de-
sired slice thickness.
• Switch on the appliance using the on/off switch.
The blade will start to turn.
• Put the food product on the carriage and adjust
the clamp to hold the product firmly in place.
Make sure the product is positioned against the
stop plate.
• Once the product has been sliced, switch off the
appliance with the on/off switch. The blade will
stop turning.
• Turn the thickness dial back to "0".
Do not use sharp or pointed objects for clean-
ing. Do not use benzene or solvents! Clean with a
damp cloth. Use washing-up liquid if needed, but
never abrasive cleaning agents.
• Clean the blade with alcohol. WARNING! The blade
is extremely sharp.
• If the food carriage stops sliding smoothly, lay the
machine on its side. Clean the slide bar carefully
and lubricate it with Vaseline
NL EN
5