Problemen Opsporen - Texas CG230B Manuel D'utilisation

15. Problemen opsporen

PROBLEM
The engine will not
start
The engine starts but
will not accelerate
The engine starts but
will only run with full
power by half choke
The engine will not run
by full speed and
exhausts heavy
smoke.
The engine starts but
will not idle
The cord will not feed
Grass is entangled
around drive shaft
house and cord house. 2. Full power is not applied
The spool box is
difficult to turn
Oil drips from the
exhaust.
POSSIBLE CAUSE
1. No spark
2. No fuel
3. Drowned engine
4. You have to pull the starting
cord harder.
The carburettor must be adjusted Contact your dealer.
The carburettor must be
adjusted, repaired or cleaned
1. Check the mixing condition of
the fuel.
2. The air filter is dirty.
3. The carburettor must be
adjusted.
The carburettor must be adjusted Contact your dealer.
1. The cord is melted
2. Insufficient cord on the spool.
3. Cord has been worn too short. Feed with cord while the cord house is by turns
4. The cord is entangled on the
spool.
5. The revolutions of the engines
are too slow
1. High grass is cut in earth
height.
Threads are dirty, damaged or
full of grass.
1. Full gas is not applied
2. Check the mixing conditions of
the fuel.
3. The air filter is dirty
4. Carburettor must be adjusted.
Inspect the spark. Dismount the sparking plug,
put the sparking plug cover on the sparking plug
and place the sparking plug on the metal
cylinder. Pull the starting cord and see if any
sparks appear from the tip of the sparking plug.
If there are no sparks you shall repeat this test
with a new sparking plug.
Push the prime bolt. If the problems continue
you must contact your dealer.
Dismount the sparking plug and turn the trimmer
around, so that the sparking plug hole turns
against the ground. Move the choke to Run
and pull the starting cord 10 to 15 times. Clean
the sparking plug and put it back in its place. If
necessary replace. Pull the starting cord three
times with the choke on the Run position. If the
engine does not start turn the choke to the
choke position and proceed with normal
starting procedure. If the engine still does not
start, repeat the procedure with new sparking
plug.
Contact your dealer.
Contact your dealer.
Use new fuel with the correct mixing conditions.
Clean or replace
Contact your dealer
Replace, The trimmer has been too close to
stones and walls.
Add cord.
pushed down and released.
Remove the cord from the spool and rewind.
Feed the cord by full power.
Cut the grass from above and downwards.
Apply full gas.
Clean the threads and grease them. If
necessary replace the spool box.
Apply full gas
Use new fuel and correct 2-stroke mixture
Clean or replace
Contact your dealer.
58
SOLUTION