Operation; Air Filter - Texas CG230B Manuel D'utilisation

How to start a warm engine
1. Switch the choke to
2. Pull the starter until the engine runs.
How to stop the engine
1. Release the gas and the safety switch.
2. Press the Stop-switch in/up.

9. Operation

High grass should always be cut from the top and downwards. In this way you
-
prevent the grass from being wrapped around the trimmer head and thereby lead to
over heating and damage. If grass and the like is wrapped around the trimmer head
the engine must be STOPPED, the spark plug cap taken off and the grass then
removed.
- For moving the line forward you tap the trimmer head lightly against the ground
while the engine runs at full speed.
Hold the trimmer at an angle towards the area that is to
-
be cut.
The illustration shows the best cutting angle (A).
-
Use the line to cut. Do not force the trimmer head into
-
grass that has not yet been cut.
Wire and fences are hard on the line and may even
-
cause it to break.
Stones and walls, and wood cause the line to be worn down very fast. Walk around
-
trees and bushes. Bark and trees, wood boarding and poles are easily damaged by
the line.

10. Air filter

For correct performance and durability the air filter must be kept clean.
1. Remove the lid of the air filter by unscrewing the screw that fastens the lid.
2. Wash the filter in mild soap water. Leave it to dry. Pour on a little two-stroke oil
Press out any surplus oil. Replace an old and worn filter.
3. Filter and lid is fitted again. Make sure that the filter and lid is secured tightened.
Clean the air filter for every 5 hours or more often if you work in dusty areas.
Choke
34
Fuel pump