Spark Plug; Storage; Trouble Shooting - Texas CG230B Manuel D'utilisation

11. Spark plug

This machine is equipped with a spark plug type W22MP-US with an electrode distance of
0,6 mm. For optimal performance it should be replaced once a year.

12. Storage

1. Empty all fuel into a can approved for petrol. Let the engine run until it stops.
2. Clean the head, and store the machine frost free and out of reach for children.
3. Observe all safety precautions concerning safe storage and handling of gasoline.

13. Trouble shooting

PROBLEM
The engine does not
start.
The engine starts but
does not accelerate.
The engine starts but can
only run on full power
and on half choke
The engine does not run
on full power and
smokes heavily.
The engine starts, runs,
and accelerates but can
not run idle.
The line cannot be pulled
forward.
POSSIBLE CAUSE
1.No spark.
2. No fuel.
3. Drowned engine.
4. The starter must be pulled
harder than when the
machine was new.
The carburetor needs
adjustment.
The carburetor must be
adjusted, repaired or
cleaned.
1. Check the mix of the fuel.
2. The air filter is dirty
3. The carburetor needs
adjustment.
The carburetor needs
adjustment.
1. The line is melted
together.
2. Too little line.
Check the spark plug. Take off the spark plug,
place the spark plug cap on the spark plug and
place the spark plug on the metal cylinder. Pull
she starter and check if there are sparks on the
top of the spark plug. If there are no sparks repeat
procedure with a new spark plug. If still no sparks
contact local dealer.
Press the fuel primer. If the problem persists,
contact your local dealer.
Remove the spark plug and turn the trimmer so
that the spark plug hole faces the ground. Switch
the choke to RUN and pull the starter 10-15
times. Clean the spark plug and fit it again. You
may also replace the spark plug. Pull the starter 3
times with the choke switched to RUN . If the
engine does not start, move the choke to Choke
and normal starting procedure is used. If the
engine still does not start, repeat the procedure
with a new spark plug.
Contact your local dealer.
Contact your local dealer.
Contact your local dealer.
Use new fuel with the correct mix.
Clean or replace.
Contact your local dealer.
Contact your local dealer.
Replace. You may be using the tool too close to
stones and walls.
Fit more line.
35
SOLUTION