Changing From Brushcutter To Trimmer - Texas CG230B Manuel D'utilisation

Only use original spare parts.
-
Only use the blade for weeds, grass and similar.
-
Throw back is something that may occur when the rotating blade gets into contact
-
with something, it cannot cut. This contact may have the effect, that the blade stops
for a moment, and suddenly the tool is thrown away from the hard object that was
hit. This reaction may be so violent that the user loses control of the tool. Throw
back may occur without warning if the blade is stuck, looses speed or impeded.
This is most likely in areas where it is difficult to see the material that is being cut.
- The harness must always be used and adjusted to fit in the correct manner.
Keep a firm grip on both handles while the blade is running. Keep the blade away
-
from your body and below your waist.

5. Changing from brushcutter to trimmer

figure 8
Dismounting the blade
1. Remove the pin(1)
Fit the holder(7) in the hole of the trimmer gear(9),
and the bearing(5) so that it fastens the axle..
2. Remove the nut(2), that fastens the blade.
3. Washer(3), spacer(4) and blade(6) may now be
removed.
Notice: Store the parts together for later use.
Mounting of trimmer head.
1. Mount the holder(7) on the trimmer head so that it
fastens the axle.
2. Mount the trimmer head by turning it anticlockwise.
3. Fasten the trimmer head tightly before use.
31