Trevi CMP 542 USB Mode D'emploi page 9

CMP 542 USB
POWER SOURCE
This unit is designed to be operated on AC/DC.
AC OPERATION
Plug the smaller end of AC power cord into AC jack on unit and the other bigger end into AC wall
outlet. The batteries will be automatically disconnected.
DC OPERATION
Open the BATTERY COMPARTMENT DOOR. Install 6 pcs 1.5V UM-2/C size batteries (not included)
into compartment. Please follow correct polarities as indicated.
CAUTION:
Remove batteries if they are flat or not being used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
BASIC FUNCTION
SWITCHING ON THE UNIT
After connecting the AC power, set the FUNCTION switch to CD/MP3/USB or RADIO, the POWER
indicator will illuminate.
NOTE:
In CD/MP3/USB position, when the unit is not providing the main function for 15 minutes,
the unit will automatically switch into standby mode.
ESD hints
– The product maybe reset or not reset to operation of control due to electrostatic
discharge, just switch off and reconnect again.
TO ADJUST VOLUME
Rotate the VOLUME CONTROL right or left to increase or decrease volume.
HEADPHONES
For private listening, plug the headphones/earphones (not included) into PHONES jack(3.5 mm
diameter).
CAUTION: Long time listening with headphones/earphones at high volumes may cause harmful
damage to users' ears.
To avoid possible hearing damage, limit the time listening at high volumes
USING THE RADIO
1. Move the FUNCTION switch to RADIO position .
2. Tune to required station by rotating the TUNING KNOB.
3. Rotate the VOLUME CONTROL to comfortable volume level.
4. Extend the TELESCOPIC ANTENNA to its full length and gently rock the unit back and forth
to get the best reception, or place the unit in an open place.
Note: The FM STEREO indicator will be on if you are receiving FM stereo program.
5. Turn off the radio by switching the FUNCTION switch to "OFF" position
9
ENGLISH