Ayce VHS01A17Z0C Manuel D'utilisation page 32

PRODUCT OPERATION
Docking Station
01 02
Installation diagram
≥15 cm
120~125 cm
≤80 cm
Floor
Tips: When installing the docking station, 4*30 mm screw is
4*30mm
Screw suggested on the wooden surface.
The 6*30 mm expansion pin and 4*30 mm screw should be
6*30mm
Expansion used on the cement surface.
pin
≈5 cm
Floor Floor
03
Fixing on the wall Hanging the product &
accessory
Screw holes
3
CAUTION
Before installation:
1. Do not install on weak structures such as plaster walls and compressed
wood boards when their thickness is
less than 10 mm.
2. To prevent fire or electric shock due to leakage, please do not install it on
metal walls.
3. Hanging area must be flat.
4. Wall holder must be placed in ambient temperature between 5℃ and 40℃.
5. Ensure screw will not damage gas pipe, water pipe or wire insides of the wall.
6. No part of the appliance should touch the ground when. placed on the
docking station.
Before use : Disconnect the appliance from the power supply before removing it
from the docking station.
WHEN STORE THE APPLIANCE:
1. Please do not apply undue force to the docking station.
2. Do not leave it lean against the wall, always store on the docking station.
3. Must be connected with extension tube and brush. Ensure not working while
stored.
4. The crevice nozzle must be removed from the extension hose prior to storage.
5. Ensure that brush and extension tube area is clear : can not be accidentally hit by
feet or other falling object.
6. Ensure that the wall holder is firmly secured to the wall.
Check regularly and tighten the screws if necessary.
62 63
GB