REMA CBKN Série Mode D'emploi page 13

11b. PROCEDURE SAFETY INSPECTION
All inspections and repairings must be written down in the maintenance diagram.
This counts not only for your own inspections but also for inspections which are carried out by your
authorised REMA distributor. When the clamp is handed in for maintenance and inspection you always
must provide the maintenance diagram.
Defective Lifting Clamps.
When a form of wear or damage is indicated, you must take the following measures.
1. Take the lifting clamp out of use. (Note the date of failure of the lifting clamp)
2. Try to recover the cause of the failure, for example (complete list is available in chapter 1):
- Overload
- Wrong and/or carelessly use
- etc
These claims stated in no.2 do not fall under the guarantee! To guarantee the security of you and your
colleagues you are obliged to follow up this procedure.
3. Return your lifting clamp (with the maintenance history) to your authorised REMA distributor.
4. If the lifting clamp has been revised / repaired by your distributor, you can safely use your clamp again.
Please note this date in your maintenance chart.
11c. INSPECTION SCHEDULE
Months
Years
Safety inspections
by your own
inspector
Maintenance by an
official REMA
distributor
Revision by a official
REMA distributor
4 8 12 16 20 24 28 32 36 40 44 48 52 56 60
1 2 3
13
4 5