BH FITNESS G-6442 Instructions De Montage Et Utilisation page 19

FAULT FINDING CHART
PROBLEM
The monitor
switch on.
The monitor switches on
but the motor fails to
start.
Walking motion is jerky
on the treadmill.
The machine stops (the
breaker trips).
Electrical shocks through
the handrail.
The treadmill belt skews
off centre.
ERROR CODES
Monitor screen displays E1
Monitor screen displays E6-E7
Hesitate to get touch with us if you have any queries, by calling:
CHECKS
does not 1) Make sure that the
machine is plugged in,
the ON/OFF switch in
position 1 and that the
safety key is inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt
is lubricated.
3.b) Check the tension
on the sliding belt.
3.c) Check the tension
on the drive belt.
4) Check that the band is
lubricated.
5)
machine is plugged into
an earthed mains socket.
6.a)
machine is level on the
floor.
6.b)
machine
wobble.
Check that
Check that
Check that
does
- Possible motor overload.
- Lubricate the belt.
- Elevation fault.
902 170 258
19
SOLUTIONS
1) Plug the machine into
the mains supply. Set the
switch to position 1 and
insert the safety key.
2) Switch the machine off
and press the circuit
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust
tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload
button with the On /Off
switch at
lubricate the
band.
the 5) Plug the machine into
an earthed mains socket.
the
the
not
the belt
„0" and
treadmill