Storch Pro 62 60 00 Mode D'emploi page 64

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Tips
• Pay attention that the blade is always sharp. Keep your
working surroundings clean and freely from rubble to
avoid an unnecessary wear of the knife.
• Do not work in a steeper angle when the underground is
softish.
• Do not cut strips wider than the working width of 210
mm.
• Work from the middle of the room to the wall.
• Take care of the cable, work to the opposite direction
from the power socket.
• Use the waved Jumboblade in Teflon in the case of
strong pasted flooring coverings.
• Do not use the 130 mm blade if you have harder cover-
ings, it could be too flexible.
• The phase of the blade can be used differently -
upwards or down showing. With down showing phase the
blade can sharpen itself (depends on subfloor!)
Maintenance and repair
General information
The tools necessary for the maintenance repair and ser-
vice works that have been described below is included in
the delivery extent of the machine.
STORCH has planned maintenance and repair works
for the Bullystripper. Only the activities that have been
described below can be applied.
When doing so, it is imperative to keep the default and
the described procedures. The application of original spare
parts guarantees the dependable utilization of the machi-
ne in the future.
The following works have been planned:
• Cleaning
• Changing the blade
Cleaning and maintenance
Caution!
Pull out the plug from the power connection before clea-
ning!
Once per week - with frequent use more often - carry out:
• Clean the chill air openings
• Blow out with dry pressure air the engine
• Remove the floor covering leftovers
Translation of the original instruction
Caution!
Exchange the wear parts in time!
Changing the blade
Caution!
Danger of cutting for the hands! Wear protective gloves!
• Unfasten the hexagonal nuts, key width 10 mm, approx.
half a rotation with the provided double ring key.
• Pull out the blade.
• Insert the new blade with the phase upwards.
• Fasten the hexagonal nuts.
Sicherheitshinweise für Wartungsarbeiten
Note!
For all works the following can be applied in general:
• The works must be done by trained personnel only.
• Any work performed on the electrical equipment may be
carried out by skilled electricians only.
• The utilisation of original parts guarantees the necessary
technical specifications.
Caution!
Material damages are possible!
The works have to be done carefully and with suitable
tools, so that no other parts of the machine are damaged
during the possible slipping of the tool.
64

Publicité

Table des Matières
loading

Table des Matières