Storch Pro 62 60 00 Mode D'emploi page 63

Designated use
The Flooring Stripper PRO is constructed for removing
pasted flooring coverings like PVC,-CV-, lino and carpe-
ting floorings.
Using the machine outdoors is not allowed.
Assembly
• Connect separated handle tubes:
Long tube with clamp – adapter tube – short tube – handle
with clamp.
• Put the cables in such a way that no trip traps can origi-
nate and it cannot be damaged.
• Fix the blade as described in chapter 7.3 „Changing the
blade"
Note!
Now the machine is ready for operation. The electrical
connection with the mains will be done only on site.
Transport
In many cases it is inevitable to transport resp. carry the
machine to the point of utilization. Due to the low weight
and the manual measurements no instruction references
are required for this.
Caution, Fragile!
Do not throw the machine and do not transport it without
securing it onto the load area.
Operation
Preparation of the machine
Adjust the handle
For a light and exact use of the machine the right height
setting of the handle is important.
Adjust the handle as described in chapter „Assembly".
Preparation of the subsurface
Before placing the machine cut the floor in stripes, pay
attention to the working width of the Flooring Stripper
PRO of 210 mm. In the case of strong pasted floors, cut it
in more narrow stripes.
If the machine is used for purposes other than those
intended, the manufacturer of the machine can not be
held liable for any damage to persons, property or pets
resulting from such misuse.
As far as possible please remove the floor covering with
the clamp.
We recommend removing a first stripe in the middle of
the room, where you can place the Flooring Stripper PRO.
Starting the machine
• Connect the Bullystripper to the plug.
• Switch on the Bullystripper at the switch.
• Place the Bullystripper in the cut area and stripe a com-
plete stripe through the room. Afterwards place the Flo-
oring Stripper PRO across the cut stripe.
• Pull the machine back with the chassis.
63 Translation of the original instruction