Blower Aperture
Mains Lead
•
To use the device please unwind the entire lead.
•
After use you can wind up the lead in the cable duct on the
motor housing.
Parking Position
Operation
General
•
Select the desired accessory.
•
Unwind the lead completely.
•
Insert the mains plug into a correctly installed 230V, 50Hz
power socket.
Dry Vacuuming
•
Insert the permanent dust bag; it may be necessary before-
hand to remove the hose connection.
•
Attach the motor housing.
•
Assemble the accessory.
•
Turn the device on.
•
Vacuum at a steady speed. There is no need to exert
pressure.
Removing and Emptying the Dust Bag
•
Turn the device off with the on/off switch (2). Pull the plug
out of the socket.
•
Remove the motor housing.
•
Take off the hose connection.
•
Remove the dust bag.
•
Empty the dust bag by pulling off the clip.
•
Push the clip back in place and reinsert the bag. Check that
it is inserted properly in the holder.
40
05-BS 1260 40
•
The device has a blower
function. This enables you to
blow out dust or leaves.
•
Attach the hose connection
(8) to the blower aperture
(12).
•
On the motor housing your
device has a holder for the
fl oor nozzle.
•
Here you can hang up the
nozzle in order to "park" it.
•
Reassemble the hose connection and the motor housing.
•
Now you can use the device again.
Wet Vacuuming
CAUTION:
•
Never use the dust bag when vacuuming up liquids.
Allow the hose connection to discharge directly into the
collection vessel.
•
Do not use the fl oor nozzle, but the parquet brush.
•
Before the cleaner is used again for dry vacuuming, all
components must be dry.
•
Remove the permanent dust bag and reattach the motor
housing.
•
Assemble the attachment.
•
Switch the device on.
CAUTION:
Turn the device off immediately if foam forms, liquid leaks out
or if the vessel is full.
NOTE:
When the vessel is full the fl oat valve (16) closes the suction
aperture and the motor runs at a higher speed. Switch the
device off immediately and empty it.
Emptying the Collection Vessel
•
Turn the device off by the on/off switch (2). Pull the plug out
of the socket.
•
Remove the motor housing.
•
Empty the collection vessel.
•
Reassemble the hose connection and the motor housing.
•
You can now use the vacuum cleaner again.
Cleaning and storage
•
Pull the plug out of the socket.
•
In order not to damage the surfaces, please do not use any
abrasive detergents or scratching cleaning utensils.
Collection Vessel
•
Rinse out the collection vessel after use with clean water.
•
Any dirt in the vessel can be removed with a sponge or
nylon brush.
Permanent Dust Bag
•
Quick cleaning: Tap or brush out the dust bag in order to
remove any residues.
•
Hand wash: If soiling is more severe we recommend a
hand wash up to 40°C.
NOTE:
•
The bag should only be allowed to dry in the air!
•
Only use the vacuum cleaner again when the dust bag is
dry!
19.09.2006, 12:54:59 Uhr