afx light FOG1500MULTI Manuel D'utilisation page 3

damage the machine.
• To fill the tank, put the machine on a level place, open the liquid tank and pour high quality fog liquid into the tank.
Close the tank immediately after filling it.
• It's forbidden to spray directly towards persons. Keep far away from flammability and explosive objects
• The fog is very hot, please keep a distance of at least 5 meters when using it
• Please don't touch the surface of the fog machine during the use because the housing will reach 40-80°C
• When the machine doesn't work, please check if the fuse is burnt out or not. If it is, replace it by an identical fuse,
find out the fault and restart the machine. But please note: the repair must be handled by professional.
Operating instructions
•
Connect the power cord. Prior to switching the unit on, make sure that it is connected to
the proper voltage.
•
Turn on the machine. It will immediately heat up. The digital display will show HEAT.
•
It takes about 4 minutes to reach working temperature. The digital display will change to
ADDR when it's ready. Press the wireless remote on the on board fog red manual button
to create fog.
How to use digital display
•
MENU button: When it shows HEAT, press MENU button to enter the page ADDR.
•
UP: Increase value for subpages
•
DOWN: Decrease value for subpages
•
ENTER: Confirm or exit
•
DMX address setting:
When ADDR is displayed, press ENTER button to set the DMX address via the UP & DOWN buttons. Then press
ENTER again to exit DMX setting.
DMX Function
The unit has 1 DMX channel: 0-5 = turn off fog, 6-255 = fog on. When the machine is heating up, the display shows
HEAT.
Wireless remote Control
There is one transmitter and one receiver included. You may control up to 4 independent fog machines, or as many
© Copyright LOTRONIC 2016
Status led
Switch
Wireless remote
control
Heating Led
Wireless receiver
Page 3