BoomToneDJ DMX-192 Mode D'emploi page 20

I-How to prgram a scene ?
Programmation d'une scène
1- Press and hold Program button for three seconds to activate program mode. The
LCD next to "Program" blinks ,indicating the program has been started.
2- Select a fixture to program, by pressing any or all Scanner buttons 1 to 12.
3- Adjust the faders to the desired output level for all channels (i.e. Color, Gobo, Pan,
Tilt, etc.)of selected fixture or fixtures. Press Page Select A/B if the fixture has
more than 8 channels. When selecting from Page A to B, you have to move
sliders to activate channels.
4- If you have set the fixture to your liking and wish to program another fixture,
press the Scanner button you have finished adjusting.
To exit programming mode press and hold the Program button for 3 seconds.
( When you exit programming ,the Blackout LED is on, press Blackout button to
de-function blackout.)
Note: This will hold the fixture in its final configuration. Select another fixture/s by
pressing the target Scanner button and proceed to adjust the faders to achieve the
settings you desire.
 Repeat steps 2 and 3 until you have set the fixtures the way you like.
 When entire scene is set to your liking, press and release the
 Select the desired bank to store scene using the Up and Down Bank
 Then press a Scene Button 1 ~ 8 to store the scene .All LED is blink 3
 Repeat steps 2 ~ 8 to record your desired scenes.
You can copy the settings from one scanner button to another in case you want to
add more fixtures to your show. Just press and hold the scanner button you want to
copy, then press the scanner button you want to copy to.
MIDI/Add button.
select button .There are 30 banks you can store up to 8 scenes per
bank for a total of 240 scenes.
times. The LCD will display the bank and scene where your scene
was stored.
19
SCENES