Publicité
Les langues disponibles
Les langues disponibles
4.- Now take the weight selector tube
(14), Fig.4, and attach the holding
collar (41) for the first weight and
insert the lockpin (40). Fit the last
weight (42) onto the bars, tighten the
bolts (63) for the guide post (13) to the
main body (10), as shown in Fig.5.
5.-Put the screws (70) into the screw
holes so that they are in their correct
position,
without
Make sure the main structure (2)
remains in a vertical position Fig.6.
6.-Fit the top body (1) Fig.7 onto the
main body (2). Hand tighten the bolts
(63) (70) as shown in Fig.7.
FITTING THE BUTTERFLY ARM
SUPPORT.-
7.- Fit the butterfly arm support (3) into
the top support (1), Fig.8. Insert bolt
(73), along with washer (78) and nut
(81), and tighten securely. Fit the nut
cap (59).
Next, place the feet support plate (12)
close to the lower support (10) Fig.8.
Fix the screws (69) with washers (76)
and tighten the nuts (80).
FITTING THE ARM LIMIT
PLATE.-
8.-Take the nuts, washers and bolts
off the arm rotation support Fig.8.
Next, fit the plate (62) with the logo
facing outward and refit the bolts,
washers and nut, tighten the bolts
securely.
FITTING THE TOP FOAM COVERS.-
9.-Take the foam covers (54) and fit
them onto the two BUTTERFLY bars,
as shown in Fig.8.
Now take the handle (15), remove the
bolt and the washer Fig.8 and screw it
on to the arms (left and right).
tightening
Fig.6.
FITTING THE SEAT
STRUCTURE.-
10.- Take the knob from the seat
support (84). Position it on one of the
two seat height setting holes Fig.9 and
secure using the knob (84).
Fit the seat locking pin (26).
FITTING THE HANDGRIP
SUPPORT.-
11.- Fit the handgrip support (7) onto
the tube for the seat frame (6), Fig.9.
Next, insert bolt (70), flat washer (76)
and tighten using nut (80).
FITTING THE SEAT.-
12.-Take the seat (24) and position it
on the seat support Fig.9.
Fit the bolts (71) with their washers
(75) and tighten securely.
FITTING THE BACKREST.-
13.-Take
the
position it against the central mast, as
shown in Fig.10.
Now use the bolts (71) and washers
(75) to secure the backrest Fig.10.
FITTING THE BOTTOM FOAM
COVERS.-
14.-First take the foam covers (53)
and fit them onto the top rounded
tubes for the leg support Fig.10.
Now do the same for the bottom leg
support foam covers (53).
FITTING THE PANELS.-
15.-Position
protection plates (22 and 21) onto the
main frame (1), fitting the plate wedge
into the accommodating groove in the
base, then tighten screws (63) slightly
in the upper part as shown in Fig.11.
13
backrest
(23)
the
left
and
and
right
Publicité
