Troubleshooting - Ryobi RY13050 Manuel D'utilisation

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Engine will not start
Engine does not reach full speed and
emits excessive smoke
Engine starts, runs, and accelerates
but will not idle
Engine emits too much smoke
Engine rope cannot be pulled

TROUBLESHOOTING

POSSIBLE CAUSE
No spark.
No fuel.
Engine is flooded.
Air filter is dirty.
Spark arrestor screen is dirty.
Spark plug fouled.
Idle speed screw on carburetor needs
adjustment.
Too much oil in crankcase.
Oil has entered the combustion
chamber.
13 — English
SOLUTION
Clean or replace spark plug. Reset
spark plug gap. Refer to Spark Plug
Replacement earlier in this manual.
Push primer bulb until bulb is full of fuel.
If bulb does not fill, primary fuel delivery
system is blocked. Contact a service
dealer. If primer bulb fills, engine may
be flooded, proceed to next item.
Set the start lever to the START position.
Squeeze the trigger and pull the rope
repeatedly until the engine starts and
runs.
NOTE: Depending on the severity of
the flooding, this may require numerous
pulls of the rope.
Clean air filter. Refer to Cleaning Air
Filter earlier in this manual.
Contact a servicing dealer.
Clean or replace spark plug. Reset
spark plug gap. Refer to Spark Plug
Replacement earlier in this manual.
Turn idle speed screw clockwise to
increase idle speed. See Figure 12.
Drain lubricant and refill with correct
amount of 10W-30 engine lubricant.
S e e A d d i n g /C h e c k i n g E n g i n e
Lubricant in the Operation section of
this manual.
This is usually caused by storing the unit
for an extended time with the engine in
an upside-down position. Remove and
clean the spark plug. Drain the oil out
of the spark plug hole, then reinstall the
spark plug.