Troubleshooting - Ryobi RY40100 Manuel D'utilisation

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position
Mower not starting
Mower cutting grass unevenly
Mower not mulching properly
Mower hard to push
Mower not bagging properly
Mower vibrating at higher speed
Motor stops while cutting

TROUBLESHOOTING

POSSIBLE CAUSE
Handle locks not locked.
Battery is low in charge.
Lawn is rough or cutting height not set
properly.
Wet grass clippings sticking to the un-
derside of the deck.
High grass, rear of mower housing and
blade dragging in heavy grass, or cut-
ting height too low.
Cutting height set too low
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi
12 — English
SOLUTION
Lock upper and lower handle locks.
Charge the battery.
Adjust the cutting height.
Wait until the grass dries before mow-
ing.
Raise cutting height.
Raise cutting height.
Replace the blade.
Stop the motor, remove fuse key and
battery. Inspect for damage. Have re-
paired by an authorized service center
before restarting.
Raise the cutting height
Help Line!
®