Télécharger Imprimer la page

Hendi 272411 Mode D'emploi page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
Burner flame is low
Note: Do not operate
heater below 5°C
Emitter glows uneven
Note: Bottom 2.5cm of
emitter normally does
not normally glow
Carbon build-up
Thick black smoke
Warning
Read the instructions before using this appliance.
The appliance must be installed in accordance with
instructions and local regulations.
The use of this appliance in enclosed areas can be
dangerous and is PROHIBITED.
For use outdoors or in amply ventilated areas.
An amply ventilated area must have a minimum of
25% of the surface area open.
The surface area is the sum of the walls surface.
EN
Warranty
Any defect affecting the functionality of the appli-
ance that becomes apparent within one year after
purchase will be corrected by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructions
and has not been abused or misused in any way.
Your statutory rights are not affected. If the appli-
ance is claimed under warranty, state where and
Discarding & Environment
At the end of the life of the appliance, please dis-
pose of the appliance according to the regulations
and guidelines applicable at the time.
10
Gas pressure is low
Outdoor temperature is greater than 5°C
and tank is less than 25% full.
Supply hose is bent or kinked
Control knob is fully " ON"
Gas pressure is low
Base is not on a level surface
Heater not level
Dirt or film on reflector and emitter
Blockage in burner
Replace gas cylinder
Replace gas cylinder
Straighten hose and perform leak test on hose
Turn control knob to "OFF", let it cool to room temperature
& check burner and orifices for blockage
Replace gas cylinder
Place heater on a level surface
Level heater
Clean reflector and emitter
Turn control knob to "OFF", let it cool to room temperature
and remove blockage and clean burner inside and outside.
when it was bought and include proof of purchase
(e.g. receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
Throw packing materials like plastic and boxes in
the appropriate containers.

Publicité

loading