Electrolux ESL 46510 Notice D'utilisation page 24

24 www.electrolux.com
2) Do not use salt at this level.
You must adjust the water soften-
er manually and electronically.
Manual adjustment
Electronic adjustment
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Press button (3).
• The indicators of buttons (4) and (5)
go off.
6.2 Filling the salt container
Turn the water hardness dial to the posi-
tion 1 or 2.
• The indicator of button (3) continues
to flash.
• The acoustic signals operate, e.g.
five intermittent acoustic signals =
level 5.
• The display shows the setting of the
water softener, e.g.
4. Press button (3) again and again to
change the setting.
5. Deactivate the appliance to confirm
the setting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3.
Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.
= level 5.