Weller PYROPEN WP 60 Manuel D'utilisation page 21

1.
1. Loosen and remove tip by turning the knurled nut to right as
2. Make sure gas control lever be at the middle.
3. Push gas open switch up.
4. Ignite as shown above with a lighter.
5. Adjust the flame height by moving gas control lever between left /
Trouble:
Does not ignite
Tip does not heat
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
HOW TO USE AS A TORCH
Knurled nut
ON OFF
shown above.
right.
HOW TO CHANGE EJECTOR UNIT
Change ejector unit when gas does
.
1. 2.
not flow.
Pull ejector unit upward, then the unit
will come off.
ON OFF
Insert new ejector unit and push the
Ejector unit
unit down till fixed.
TROUBLE SHOOTING
Problem cause:
1. Empty gas
2. Ejector unit breakage,
clogging, or used up
3. Gas pressure too
high or too low
1. Used up catalyst
2. Insufficient gas
pressure
. .
2. 3. 4. Gas control
lever
ON OFF
Gas open
lever
Problem cause:
1. Empty gas
2. Ejector unit breakage,
clogging, or used up
3. Gas pressure too
high or too low
1. Used up catalyst
2. Insufficient gas
pressure
21