Kenwood SW-05HT Mode D'emploi page 3

Connections
Note on connection
1. Be sure to turn off your amplifier before connecting
or disconnecting speaker.
2. This speaker system has a nominal impedance of 8
ohms. To drive this speaker satisfactorily and safely,
use an amplifier which can be connected to the
speaker having a load impedance of 8 ohms.
÷ Never short-circuit the + and - speaker cords.
1 2
Twist wire's
Push
conductor
SW-05HT
Black
Red Blue
Speaker terminals (Receiver)
Note on operation
The power-handling capacity of this speaker system
is indicated in the specifications. Do not operate the
speaker with power exceeding this limitation, as it
may damage the speaker.
3 4
Insert the Release
conductor
Right Left
Black
Black
Red
Black
Specifications
Type .............................................................. Subwoofer
Enclosure .................................................... Bass-Reflex
Loudspeaker ............................ 200 mm (8 ") Cone type
Nominal Impedance .................................................. 8 Ω
Maximum Input Power ...................................... *100 W
Nominal Input Power ............................................ *50 W
Sensitivity ................................................ 83 dB / at 1 m
Frequency Response ........................... 40 Hz ~ 1,000 Hz
Dimensions ........................ Width: 300 mm (11-13/16 ")
Net Weight .............................................. 8.2 kg (18.1 lb)
Enclosure Finish
High density particle board laminated with simu-
lated wood grain vinyl.
* Achieved when both front speaker KS-205HT and the
Subwoofer driven.
Accessories
Speaker Cord (Red/Black x 1, Blue/Black x 1)
Note:
Blue
KENWOOD follows a policy of continuous advancements
in development. For this reason specifications may be
changed without notice.
SW-05HT(EN)
Height: 420 mm (16-9/16 ")
Depth: 385 mm (15-3/16 ")
3