PROMAT 4000877148 Mode D'emploi Original page 10

Charging the Battery
Use the included USB charging cable to connect the charging socket (6) of the
lamp to a suitable USB port or use the included vehicle adaptor to connect it to the
12 or 24 Volt electric system of a vehicle or boat.
During charging the charging control light (2) on the front of the lamp lights up red,
when the charge is complete it lights up green.
After charging, disconnect the lamp from the charging cable.
Operation
 Below the light panel (1) is the ON/OFF button (3). Press the ON/OFF button to
turn on the lighting panel. Press the ON/OFF button again within two seconds to
turn on the single LED on the top of the lamp. Press the ON/OFF button once
more to turn off the lamp altogether.
 Pull one of the hanging hooks (4/7) out of the top of the lamp to hang the lamp
at a desired spot. This way you have both hands free for work.
 The lamp can also be attached to magnetic objects with the magnetic
holders (5/8) on the back and on the bottom of the lamp. The magnetic holder
on the bottom of the lamp is tiltable.
Maintenance and Storing
Do not use aggressive chemicals, solvents or abrasives to clean the lamp. Do not
allow liquids of any kind to enter the lamp or immerse the lamp in liquids of any
kind.
Store the lamp in a place away from direct sunlight, dust, humidity, extreme
temperatures and vibrations and out of the reach of children.
6
Operation