Pontec PondoStar LED RGB Set 3 Notice D'emploi page 13

Maintenance and cleaning
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
If necessary, clean the unit with clear water using a soft brush.
• Ensure that no moisture can enter the unit.
Changing the battery
How to proceed:
 D
Open the battery compartment.
Pull the battery from its holder and replace it.
– Pay attention to the polarity of the batteries.
Push the battery holder into the remote control.
Wear parts
• Battery
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.
Technical data
Area
Transformer
Receiver
Spotlight
Remote control
Weight
Rated voltage
Output voltage
Max. power output
Protection type
Length of power cable
Protection type
Max. immersion depth
Operation at water temperature
Length of the connection to receiver
cable
between the spotlights
Dimensions (∅  H)
Max. power consumption
Type button cell
PondoStar LED RGB Set 3
V AC / Hz 230 / 50
V AC 12
VA 12
IP 44
m
IP 44
m
°C +4 ... +35
m
m
mm 125  125
W
CR2025
kg 0.75
- EN -
2
1
3
2
5
13