Dometic Waeco CoolMatic CD50 Notice D'utilisation page 36

Installing and connecting the refrigerator
Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides). Therefore make sure there is adequate
ventilation (fig. 4, page 4).
No. in
fig. 4, page 4
1
2
3
4
The condensation which forms during normal operation of the refrigerator
can be drained off via two outlets on the appliance. For delivery purposes,
these outlets are sealed. The two outlets are located on the rear and on the
underside of the appliance (fig. c, page 8).
➤ Choose the condensation outlet most suitable for the place of installation
and remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
If you put the refrigerator in a recess, you can fix it inside with suitable
screws:
➤ Remove the blanking plugs (fig. 3 2, page 4).
➤ Push the refrigerator into the recess.
➤ Use suitable screws (fig. 3 1, page 4) to fix the refrigerator in place.
➤ Press the blanking plugs (fig. 3 2, page 4) into the openings.
36
Explanation
Cold intake air
Hot waste air
Condenser
Spacing above the fridge if insufficient air can circulate above
or at the side.
CD50, CRD50
EN