Meister MET36ME Traduction Du Manuel D'utilisation Original page 58

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
MW-5459600-Bedien-1807_(98) 18.07.18 09:44 Seite 58
d) Disconnect the power tool
from the power or from the
battery when a staple is stuck
in the power tool. When the
tacker is connected, it can be
accidentally operated when
removing a jammed staple.
e) Be careful when removing a
jammed staple. The system can
be cocked and the staple ejected
vigorously while trying to unjam.
f) Do not use this power tool for
attaching electrical cables. It is
not suitable for the installation of
electric cables, it can damage
the insulation of electric cables
and thus cause electric shock
and fire hazards.
g) Use suitable search devices to
detect hidden power lines or
consult the local utility
company. Contact with the power
lines can cause fire or electric
shock. Damaging of a gas pipeline
can cause an explosion.
Penetration into a water pipe
causes property damage.
h) Secure the work piece. A work
piece held in place with clamps
or vice is held more securely
than with your hand.
i) Protect the power tool from
heat, e.g. also from permanent
sunlight, fire, water and
moisture. In these instances,
there is a danger of explosion.
j) Damage may result if the
58
battery is damaged or used
improperly. Seek fresh air and
consult a doctor if you have a
problem. The vapours may
irritate the respiratory tract.
Safety instructions for the
charger.
WARNING! Danger of injury!
This charger is not intended
for use by children and individuals
with limited physical, sensory or
mental capabilities, or lack of
experience and knowledge.
− Supervise children. This ensures
that children do not play with the
charger.
− Cleaning and maintenance of the
charger by children must not be
carried out without supervision.
WARNING! Danger of electric
shock! Improper handling of
the charger can cause electrical
shock.
− Do not expose power tools to
rain or wet conditions. The
ingress of water into a power
tool will increase the risk of an
electrical shock.
− Only charge the power tool with
the supplied charger.
− Keep the charger clean. Soiling
creates the risk of electric shock.
− Before each use, check the
charger, the cable and the plug.
If damage is found, do not use
the charger.

Publicité

Table des Matières
loading

Table des Matières