Lubricating The Chain; Battery - for_q FQ-AHE 4020 BASIC Mode D'emploi

Lubricating the chain

Caution! The unit may be op-
erated with adequate chain
lubricating oil only. Inadequate lu-
brication will reduce the service
life of the power tool.
1. Check the chain oil level at the oil
level indicator and top up with
chain oil if required.
2. Fill the unit only with an envi-
ronmentally compatible quality
chain and bar lubricant (accord-
ing to RAL-UZ178).
3. Do not use waste oil. Renewed
contact with waste oil can cause
skin cancer. Waste oil is environ-
mentally harmful. Waste oil does
not have the necessary lubricat-
ing properties and is unsuitable
for chain lubrication.
4. Any oil other than the one recom-
mended may damage the guide
bar, the chain and the lubricating
system.
5. Ensure that dirt does not get into
the oil tank.
6. Avoid spilling oil. Always wipe up
any spilled oil.
Checking the chain lubrication
1. Start the unit (see "Switching on/
off").
2. Hold running pole saw chain for
some time approx. 15 cm above
a suitable surface. If there is ad-
equate chain lubrication, the oil
which is ejectedby the saw chain
will form a light trail.
EN
172

Battery

STATE OF CHARGE
Press the button to check the state of
charge on LED indicator. To charge
consult the user manual of the charg-
er.
≤ 25 %
≤ 50 %
≤ 75 %
≤ 100 %
Harness
Adjust the harness to a length, so
that the connector is at the height of
your belly button.
Attach the harness to the harness
connector 5 of the machine. During
operation, always wear the harness
for better weight distribution of the
machine.
Warning! In case of emer-
gency, use the harness clip to
quickly remove the machine.