Sharp R-CD1200M Mode D'emploi page 14

* Suppose you want to set Program Lock ON.
Procedure
1 Press the CUSTOM HELP pad
CUSTOM
x 2
twice within 2 seconds.
HELP
2 Enter 3, 2 for Program Lock
3 2
ON.
3 Press the START pad to
save the setting.
START
4 Press the STOP/CLEAR pad
STOP
to exit from the Custom Help
CLEAR
Function.
NOTE : If you select Program Lock OFF, the LOCK
indicator in the display will disappear when you press
the START pad.
Operation when Program Lock ON is set
KEY
Custom Help Title
Operation
Selecting Memory
1
Input Method
Selecting Auto Start
2
Operation
Program Lock
3
Setting
Audible Signal
4 Sound Volume
Setting
Cooking Completion
5
Signal Setting
6 Memory Check
Counter Check/Clear
7
Air Intake Filter
8 Counter
Selecting Operation
9 in case of Magnetron
Failure
Multiplication
x2/x3 Factors for Double/
Triple Quantity
EXPRESS Express Defrost
DEFROST Setting
When Program
Lock ON is set
no operation
no operation
operation
no operation
no operation
operation
check : operation
clear :
no operation
check, clear :
operation
set : no operation
no operation
check : operation
set : no operation
check : operation
set : no operation
EN-13
4. Audible Signal Sound Volume Setting
The volume of the audible signal can be adjusted to
High, Medium, or Mute.
CH41 : High = Factory Setting
CH42 : Medium
CH43 : Mute
To set cooking completion signal volume
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
4, 1 for High
4, 2 for Medium
4, 3 for Mute
Press the START pad to save setting and the STOP/CLEAR
pad to exit from the Custom Help Function.
NOTE : Even when errors occur, your oven will not beep
in mute setting.
5. Cooking Completion Signal Setting
There is a choice of 4 different signals on your oven.
CH51 : 1 long beep = Factory setting
CH52 : Repeating long beeps
CH53 : 4 short beeps
CH54 : Repeating short beeps
To set the signal type
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
5, 1 for 1 long beep
5, 2 for repeating long beeps
5, 3 for 4 short beeps
5, 4 for repeating short beeps
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
6. Memory Check
Use this setting to check the programming for a certain
memory.
* Suppose you want to know the information
programmed into memory 1, programmed
for 4 minutes at 60% for the 1st stage and
2 minutes at 30% at the 2nd stage programmed Dual
Digit Input.
Procedure
CUSTOM
6
HELP
x 2
1 Press the CUSTOM HELP pad
twice within 2 seconds and
enter 6.
Display
NO. CHECK