To Reset The Counter To "0 - Sharp R-CD1200M Mode D'emploi

To Reset the Counter to "0"

Each counter can be manually reset to "0" by pressing
the START pad after the count is displayed.
* Suppose you want to reset the count for memory
number 1 in any Memory Input Method
Procedure
CUSTOM 7
x 2
HELP
1 Press the CUSTOM
HELP pad twice within 2
seconds, then enter 7 .
Total usage will be
displayed.
2 Enter memory
number 1 to
check the total
memory usage of
memory 1.
START
3 Press the START pad.
STOP
CLEAR
4 Press the STOP/CLEAR pad
to exit from the Custom Help
Function.
NOTES:
1. Only Dual Digit Input method can be used when
inputting memory numbers in Counter Check/Clear.
2. To clear total manual cooking usage, press the SELECT
TIME pad in Step 2 instead of the number pad.
3. To clear total Express Defrost usage, press the
EXPRESS DEFROST pad in Step 2 instead of the
number pad.
4. To clear total usage, skip Step 2.
8. Air Intake Filter Counter
Use Custom Help Function for Air Intake Filter Counter
to check total usage hours since the Air Intake Filter was
last reset to "0".
CH81 : The total used air intake filter time
appears.
CH82 : The limit time for using a fi lter can be
changed.
After about 1 sec.
CHECK
0
NO. CHECK
1
NO. CHECK
After about 1 sec.
CHECK
CHECK
Use Custom Help Function for Air Intake Filter Counter
to change the Air Intake Filter cycle from 001-999. The
factory setting is 100 hours. When 100 hours is exceeded,
the FILTER indicator on the display will start to fl ash on
and off as a reminder to clean the air fi lter, even if in the
middle of cooking. Furthermore "FILt" fl ashes on and
off in stead of displaying " . " during standby and at the
same time FILTER indicator fl ashes on and off. Clean Air
Intake Filter (See page EN-23 - EN-24), when the FILTER
indicator appears in the display, and then clear the total
usage to reset it to "0" .
* Suppose you want to know the total usage hours
which has been 99 hours since the last reset.
Procedure
CUSTOM
HELP
x 2
1 Press the CUSTOM HELP
pad twice within
2 seconds and enter 8, 1.
STOP
CLEAR
2 Press the STOP/CLEAR pad to exit from the
Custom Help Function.
To Reset the Air Intake Filter Counter
Reset the Air Intake Filter Counter after cleaning the air
intake fi lter.
* Suppose you want to reset the air fi lter counter which
has been 101 hours since the last reset and the Air
Intake Filter cycle is preset to 100.
Procedure
CUSTOM
8 1
HELP x 2
1 Press the CUSTOM HELP
pad twice within
2 seconds and enter 8,1.
START
2 Press the START pad to
reset the counter to "0".
STOP
CLEAR
3 Press the STOP/CLEAR pad to exit from
the Custom Help Function.
EN-15
Display
8 1
After about 1 sec.
CHECK
Display
After about 1 sec.
CHECK FILTER